Transition state



The transition state of a chemical reaction is a particular configuration along the reaction coordinate. It is defined as the state corresponding to the highest energy along this reaction coordinate. At this point, assuming a perfectly irreversible reaction, colliding reactant molecules will always go on to form products [1]. The transition state shown below occurs during the SN2 reaction of bromoethane with a hydroxyl anion.


History of concept

The concept of a transition state has been important in many theories of the rate at which chemical reactions occur. This started with the chemical kinetics which are still used today.

Explanation

A collision between reactant molecules may or may not result in a successful reaction. The outcome depends on factors such as the relative kinetic energy, relative orientation and internal energy of the molecules. Even if the collision partners form an activated complex they are not bound to go on and form products, and instead the complex may fall apart back to the reactants.

Observing transition states

Because of the rules of quantum mechanics, the transition state cannot be captured or directly observed; the population at that point is zero. However, cleverly manipulated IR spectroscopy was developed for precisely that reason, and it is possible to probe molecular structure extremely close to the transition point. Often along the reaction coordinate reactive intermediates are present not much lower in energy from a transition state making it difficult to distinguish between the two.

Locating Transition States by Computational Chemistry

Transition state structures can be determined by searching for first-order saddle points on the potential energy surface. Such a saddle point is a point where there is a minimum in all dimensions but one. Almost all quantum-chemical methods (DFT, MP2, ...) can be used to find transition states. However, locating them is often problematic as the starting structure must be very close to the actual TS. Methods for locating transition states are QST2 or QST3 where the starting structure is determined from the substrate and product geometries. It is often easier (especially for large systems) to optimize to a transition state geometry using semiempirical methods such as AM1 or PM3, and then use the geometries obtained as input for better methods.

The Hammond-Leffler postulate

The enthalpy.


The Structure-correlation principle

The structure-correlation principle states that that structural changes which occur along the reaction coordinate can reveal themselves in the ground state as deviations of bond distances and angles from normal values along the reaction coordinate. [2]. According to this theory if one particular retro-Diels-Alder reaction.

Compared to the compound on the right (which,lacking an coupling constants (inverse linear relationship with bond length).


Implications for enzymatic catalysis

One way in which catalysis proceeds is by stabilizing the transition state through electrostatics. By lowering the energy of the transition state, it allows a greater population of the starting material to attain the energy needed to overcome the transition energy and proceed to product.

References

  1. ^ Solomons, T.W. Graham & Fryhle, Craig B. (2004). Organic Chemistry (8th ed.). John Wiley & Sons, Inc. ISBN 0-471-41799-8.
  2. ^ From crystal statics to chemical dynamics Hans Beat Buergi, Jack D. Dunitz Acc. Chem. Res.; 1983; 16(5); 153-161. doi:10.1021/ar00089a002 10.1021/ar00089a002
  3. ^ Manifestations of the Alder-Rickert Reaction in the Structures of Bicyclo[2.2.2]octadiene and Bicyclo[2.2.2]octene Derivatives Yit Wooi Goh, Stephen M. Danczak, Tang Kuan Lim, and Jonathan M. White J. Org. Chem.; 2007; 72(8) pp 2929 - 2935; (Article) doi:10.1021/jo0625610
 
This article is licensed under the GNU Free Documentation License. It uses material from the Wikipedia article "Transition_state". A list of authors is available in Wikipedia.